W c maximum inlet pressure in standing pilot applications using an immersion allowed for proper operation.
Honeywell water heater gas control valve manual.
The honeywell valve uses a thermopile instead of a thermocouple as did previous designs.
Page 2 high humidity or dripping water m36122 dripping water can cause the control to fail.
When referring to your water heater always have the information listed on the data plate readily available.
Retain your original receipt as proof of purchase.
The wv4460e water heater control system is designed for power vent water heater applications.
Water heater control full rate fire or explosion hazard outlet pressure should match this rating.
Page 7 wv4460e power vent water heater controls perform gas leak test gas input and burner ignition check and adjustment 1.
Water heaters covered by this handbook are equipped with honeywell gas control valve thermostats.
Maximum torque on the inlet is 40 ft lbs.
Maximum torque on the outlet is 30 ft lbs.
Sequence of operations wv4460e.
Unpacking the water heater warning excessive weight hazard.
Check the full rate manifold pressure listed on the warning appliance nameplate.
Connect the pipe to the water heater control inlet and outlet.
Use a wrench on the square end of the water heater control.
Position compression fitting in pilot outlet and engage threads.
The wt8840 water heater control is designed for use 0 5 psi 14 0 in.
A data plate identifying your water heater can be found next to the gas control valve thermostat.